China Factory Suppliers Clean Water Jet Pump VCLP for Efficient Swimming Pool Filtration and High Volume Water Transfer
Applications
- Filter centrifugal pumps are designed for cleaning swimming pool, They are suitable to transfer high volumes of water (not exceeding 45°C) against low head.
- The pump should be installed in an enclosed environment, or at least sheltered from inclement weather.
Motor
- Two-pole induction motor(n=2850 r.p.m)
- Insulation Class B
- Protection IP44
- Continuous service S1
- Thermal protector for single phase
- Single-phase 220V/50Hz, 60Hz if request
- Three-phase 380V/50Hz, 60Hz if request
Operating conditions
- Liquid temperature up to 45°C
- Ambient temperature up to 40°C
- Total suction lift up to 5m
Component Construction
- Pump body: Techno-polymer
- Pump support: Aluminum, Cast iron for HFC- 1500/2200
- Motor housing: Aluminum, Alloy for HFC-550/750
- Impeller: Techno- polymer
- Motor shaft: AISI304 SS
- Mechanical seal: SIC/Graphite
Frequently Asked Questions (FAQ)
Q: What are the primary applications for these filter centrifugal pumps?
These filter centrifugal pumps are designed specifically for cleaning swimming pools. They are suitable for transferring high volumes of water against low head, provided the water temperature does not exceed 45°C.
Q: Where should this pump be installed?
The pump should be installed in an enclosed environment, or at least sheltered from inclement weather, to ensure proper operation and longevity.
Q: What are the technical specifications of the pump motor?
The motor is a two-pole induction motor (n=2850 r.p.m) with Insulation Class B, Protection rating IP44, and is rated for continuous service S1. It also features a thermal protector for single-phase models.
Q: What power supply options are available for the motor?
It supports single-phase 220V/50Hz (60Hz upon request) and three-phase 380V/50Hz (60Hz upon request).
Q: What are the limits for liquid temperature and suction lift?
The pump can handle liquid temperatures up to 45°C, operate in ambient temperatures up to 40°C, and has a total suction lift capability of up to 5m.
Q: What materials are used to construct the pump components?
The pump body and impeller are made of Techno-polymer, the motor shaft is AISI304 SS, and the mechanical seal is SIC/Graphite. The pump support and motor housing are made of aluminum, with cast iron used for HFC-1500/2200 support, and alloy for HFC-550/750 motor housing.